![]() Some default "tsv" files aligned with the STM32 Flash memory mapping (e.g. The Flashlayout includes a formal description of the partitions (ID, naming, type, offset) as well as the identification of the Flash memory to be populated. The STM32Cubeprogrammer tool uses the Flashlayout.tsv file as an input. ![]() The selection of the binaries to download and the Flash memory destination is done through the flashlayout.tsv file. This operation requires a communication interface between the STM32CubeProgrammer and an embedded programming service. STM32CubeProgrammer is now ready to use: to know more about this tool, please continue reading otherwise, jump to the Starter or Distribution Package article corresponding to your board: Category:Starter Package or Category:Distribution Package.įlash programming consists in transferring the binaries stored on the host computer into the platform Flash memory(ies), via a serial interface. To validate the installation, the DFU driver functionality can be verified by following the FAQ instructions provided in how to check if the DFU driver is functional. In case of issue, refer to How to proceed when the DFU driver installation fails on Windows host PC. It is located in the DFU driver folder, \Drivers\DFU_Driver. This driver (installed by STM32 Bootloader.bat) is provided within the STM32CubeProgrammer release package. Run the “STM32 Bootloader.bat” file to install the STM32CubeProgrammer DFU driver and activate the STM32 microprocessor device in USB DFU mode. To allow STM32CubeProgrammer to access the USB port through low-level commands, proceed as follows: ![]() Once done, you can skip this section and jump to next one."> If not yet done, please install this package:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |